Joining your SPA525 to a wireless network.

To set up the Cisco SPA525G and Cisco SPA525G2 wireless connection please follow the steps below.
  1. Connect your phone to power using the included power cable. (Do not connect a network cable to the phone while using wireless connection.)
  2. Press the setup button. (Page Icon)
  3. Scroll to Network Configuration and press select.
  4. In the Wi-Fi field press the right arrow key to turn on the wireless option.
  5. Select Save to save the changes.
  6. Scroll down to Wireless Configuration and press the right arrow key.
  7. Press select to set Wireless Profile.
  8. Press Scan to scan for local wireless networks.
  9. Choose your wireless network and press add.
  10. Use the right arrow key to select your wireless security type. Most new routers are WPA2 PSK.
  11. Arrow down to WPA Shared Key and enter your network password using the letters on each number key.
  12. Press Save.
  13. Highlight your network name and press connect.
  14. If you are unable to connect please press the option key and go into Edit mode. This will bring you to the wireless connection settings. Try using WPA PSK and also changing the Cypher type from TKIP to AES CCMP. Also please re-enter your password.
  15. Once connected you should see the light next extension number in the upper right hand corner turn from orange to green. If you do not see an extension number, please contact support to make sure the device is added to your account and to get programming instructions.
Have more questions? Submit a request


Article is closed for comments.
Powered by Zendesk